atcomsystems.ca/forum Forums Wiring - Telecom Carriers - Trunks & Services T1's, CSU's and DSU's Can a noob do inside wiring for T1?

I don't have DCD. I did get a shock when I touched the wires

Outside on the box I have a green and red screws.
I hooked up RX pin 4 to red and 5 to green. Then I did TX 1 to green and 2 to red.

I went into the router config and I don't see DCD.

Since I'm pretty sure I have TX and RX right, should I switch the pairs? Also, I'm using a regular Cat 5E Patch cable to go from my jack to the router. is this OK?

Thanks for the all the help.