I'm pretty sure that the terminals for the standard-sized clips used in outside plant and station work use a much larger screw hole and hardware. Also, they are not rings, but spade lugs. The ones TTY Joe has are definitely for the eentsy screws that need the guide-pin screwdriver for insertion.

In addition, the length of the leads and the heat shrinks lead me to my belief about the 360 tools.

I just found an old test cord with a 360 tool at each end, so I'll send that instead of a 310 plug. Then Joe will need to find the little crocodile clips that fit into the 360 tools. I probably have a bunch at the bottom of the pile.

Arthur P. Bloom
"30 years of faithful service...15 years on hold"