atcomsystems.ca/forum Forums TDM Business Telephone Systems Comdial Telephones & Systems Digitech Phone Compatibilty

I just pulled those files, it looks like the matrix 2000 is the system 2000 not the original dsu, if it is the dsu it only goes to 12b. The dsu 2 shows rev a and later as having everything! Is there anything on dsu 1 that shows the enhancements of the 15a, 17 20 and beyond if there are any? I only remember dsu 1 going to level 20a. I think somewhere in there they released the impac software (which supported both the impac and digitech tel sets) to everyone, thats the cross reference this guy needs.
mark

Digitech support is available on all Impact level software including FX platforms. I loaded a DSU software/hardware guide on the ftp site under the dsuII. That may be what you're looking for.

Sorry, had the matrix mislabled.

Jwooten loaded the correct one. (thx!)

I use these all the time. I have them printed out in my tech facts manual at the office.

------------------


WWW.THEBESTPHONESUPPORT.COM

WWW.ABUGSEYEVIEW.COM

[This message has been edited by BIGDOG3c (edited February 26, 2005).]

That's exactly what I was looking for.

13b and up supports Inpact and Americom sets and, 20a and b also support Impact SCS sets.

you have 16a, that should support the Impact and Americom sets and the scout, If I'm reading that matrix correctly.

If your going to upgrade for phone compatability, you might as well go all the way to 20b - the cost difference probably wouldn't be much.
mark



[This message has been edited by markk (edited February 26, 2005).]