atcomsystems.ca/forum Forums TDM Business Telephone Systems Nortel Telephones & Systems upgrading MICS issues

Just another trick for nortel on the MIC's, always start on the right side? :rofl: :rofl:

will try it out on monday or tuesday....many thanks!

nope. still didn't work. did the **startup (just to be sure), powered down. inserted 6 port fiber module, powered up, did **startup.

still can't see the 0X16 module in fiber #3 or the new nam on fiber #8.

am i doing it right or do you think i have a back fiber expansion?!

at least it booted up when i stuck the fiber expansion card in slot#2!!

Make sure that your fiber clicked in when you inserted. Red light inside 6 port expn or your 0 x 16 or NAM Module has to go away. If light is up your fiber is not in.

BDW Your Stn.Module should be shown in Hardwere automaticelly. If it isn't and you have an option to Change do it then go into Maintenence and if it shows Unequiped Disable it manually and Enable it again. Port #3 is the lowest on the 6 port expension and #8 on the top. Nortel recomendes keep #8 & #7 for the Trunk expension.

red lights were all on in every port.

did that very thing. disabled & re-enabled. still didn't show.

i tried the nam & the 0X16 in several other ports as well.

And your fiber patch cables you are using are new?

try placeing phone on 1st new station port...think wont show until phone plugged in

[QUOTE]Originally posted by luv2ski:
try placeing phone on 1st new station port...think wont show until phone plugged in [/QUOTE
On any station port on that 0x16. Good call Ski.

As for the NAM, after you plug it in, how long are you waiting for it to come up?

nickels>>tried different fiber cords.

luv2ski>>phone showed nothing. and i wouldn't thinkit would until the mics see's the card

nickles>>i have waited up to 20 minutes for the nam and/or the 0X16 to come up. as a matter of fact they are STILL plugged in and the system STILL doesn't see them as of today. so over 24 hours.