atcomsystems.ca/forum Forums TDM Business Telephone Systems Mitel Telephones & Systems Toll deny

I have toll deny on my rooms extensions yet these rooms are still able to make calls to cell phones.. The setup worked originally and no settings have been changed with either COS or TD parameters.
Access to a trunk is "9" then dial the number..Cells start with 455...land lines start with 625 I don't know why it restricted the cell calls before but letting them thru now.. Any advise?? Thanks

Which Mitel system ae you using?

SX200 analog with 217 processor

Typically toll deny is caused by Outging Call Restriction enabled, let me check my old books for that one.

are you using single digit or multidigit toll restriction? Also be aware that there are ways to get around single digit toll deny (and I haven't figured a way to stop it on the fifty - haven't come up with an analog with the problem. I work with a bunch a properties that deal mainly with railroad crews. Like motel 6 they restrict all 1+ dialing from the rooms (except toll free of course). Someone found out that they could pick up the phone and dial *82 (service code to disable outgoing caller ID block) once they did that and had dial tone returned they could then dial the 1+ number and the switch let the call go since it didn't see it as a restricted string. I had to go in and restrict * as a leading digit in the string.

Is 217 compatible with NANP? I seem to remember NOT.

I think the multi digit toll control is based on the old plan of X0X and X1X area codes. Not sure if later 318 (or Dean cards - if you can find one) addressed this issue.

If you study your SMDR raw printout, you'll probably find the problem. They are probably doing some sort of dial-around. Motel customers seem to be able to beat the most intensive T/R, you have to stay ahead of them. For some of them, it's a mental challenge! That said, if you can show us some of the suceessful, supposed to be blocked, calls, we may be able to nail it down. And they may be taking advantage of dial-tone return that the Mitel is not coping with. John C.

I talked about dial arounds before and the problem I had with them. If you go to a room and dial 9 then dial *82 or *70 then get a stutter tone then a dial tone back then dial a 1+ call and it goes through that is probably, as lightning horse said, your problem. If that is the case you are not going to be able do deny it with the software you have in the PBX. You might try contacting the telco and asking to disable those feature access codes but they usually won't do (or tell you they can't) Good luck

I talked about dial arounds before and the problem I had with them. If you go to a room and dial 9 then dial *82 or *70 then get a stutter tone then a dial tone back then dial a 1+ call and it goes through that is probably, as lightning horse said, your problem. If that is the case you are not going to be able do deny it with the software you have in the PBX. You might try contacting the telco and asking to disable those feature access codes but they usually won't do (or tell you they can't) Good luck