Take a hard drive with you to any home improvement store, (Lowes, Home Depot, etc) and go to the aisle with 6-10 screws in a bag. Figure out which one it is and make sure you get SHORT ones. Thread is,.... 4-40, maybe 6-32? If they aren't short enough, wire connector crimp tools usually have built in bolt-cutters of the correct size. Remember to run the screw in from the thread side of the tool. Otherwise, you only get to cut one bolt unless it's way long and hangs out the other side.

When I was young, I was Liberal. As I aged and wised up, I became Conservative. Now that I'm old, I have settled on Curmudgeon.