atcomsystems.ca/forum Forums TDM Business Telephone Systems Avaya - Lucent Telephones & Systems Partner Messaging R.7

Yes it would need a new message.

With the number string you put in I don't see it dialing anything for your pager to let you know it called, something like 9*626XXXX*****911#, so when it gets your pager you can see what number called you.

Are the VM extensions part of the dis-allow list 7?

No they are not

In program 401 what is port 38 set at?

Do not set the ALS AT ALL for the voice mail ports, simply putting them in Hunt Group 7 will automatically set their ALS properly. If you have messes with that, take them out of the group, and then put them back in.

Put an Auto-Intercom button for each of the voice mail ports on a phone, and watch for then to light up when you call the mailbox, and then for the last one to light up while it outcalls. Does a line light up at the same time?

Put your butt set on the line and listen as it outcalls, to see what is being dialed. Perhaps the call is failing at the CO, or if it is a pager, it is taking more rings than expected to be answered by the paging service.

True it will take care of itself when you assign 505-7.

#401 is set to no restrictions. How long should it take from the time you leave a new message for the system to actualy call out to the pager number?

Thanks a bunch!

The default for Outcalling Interval is 15 min. unless you change it.

Is the lowest 5 min?

That's how long it waits between attempts to dial out to your list after the first one has been sent. It should attempt to dial after the message has been left within the start and end time that you have setup assuming that the Vms isn't getting heavy traffic. Mine takes about a min and a half.

Did you get it to work yet?




[This message has been edited by dtmf (edited April 12, 2005).]