atcomsystems.ca/forum Forums TDM Business Telephone Systems NEC Telephones & Systems Audiocodes MP112 to SV9100

Has anyone successfully setup an Audiocodes MP112 to SV9100? I'm trying to get one setup and running into some difficulty. It will register both FXS ports/extensions with the SV9100. I can call from the FXS ports to other extensions without issue.

What I can't do, is call the analog extensions from a desk phone or call an outside number from the analog extensions.

I'm close, but just can't figure it out.

Thanks.

Use port 5070 not 5060

15-05-18 allow IP duplication.

You might need to assign a unique CAP key to each ext as well.

Also is it on the same network or elsewhere?

Yep, using port 5070 and IP duplication is enabled. It's on the same network.

I'm sure I'm missing something simple somewhere.

Does the phone it's calling from ring at all in the handset?

I was testing this a bit more over the weekend. Looking into the status and diagnosis screen I can see my calls failing because they aren't routing correctly. Now I just need to figure out where it's failing. Unfortunately there just isn't any documentation out there.

You should get Audiocodes on the phone. There are so many SV9100 system in play I have a hard time thinking that if it can be done it has been. Seriously though an analog card for the system is probably cheaper and better in all ways.

Yeah, I would have thrown an analog card into the system. However, this building is remote and only has a piece of fiber connecting it to their main site.
I'll give the Audiocodes support a call.

Why not setup a MLC on a smart phone?

I have 5 of these working on my 9100 system.
PM sent.