atcomsystems.ca/forum Forums Other TDM Phone Systems Siemens Telephones & Systems Siemens OptiPoint 410 Standard Factory Reset

All,

I recently purchased a Siemens OptiPoint 410 S to use as a PoE SIP phone with my VoIP service. The seller that sold it wasn't proactive enough to get the administrator password from the hospital IT administrator where it originally came from, and he is dragging his feet big time about getting me the password from them. I'd like to get this phone in a usable state. I can't seem to do much of anything without the password. Does anyone know of any hard reset procedures that I can run on the hardware within the phone (i.e. shorting a pin, etc).

I have already tried the reset passwords, obvious passwords like 000000 and 123456, 654321, and everything listed online on this phone.

Hoping I can find a solution here.

As always, any help is appreciated.

Scott

Wish I could help on this one Scott, but Siemens is outside my range.

Oh...Happy New Year!

Try this....


optiPoint 410 entry S

Disconnect phone from LAN (except PoE).
Press keys simultaneously 389.
Press the key *.
Type in reset password 124816
Press the key #.

If you have the display non base 410 S you might try this....

Disconnect phone from LAN (only required for netboot < V2.01, PoE devices temporarily need external power supply).
Lift handset.
Type in reset code -+*3
Type in reset password 124816 and press the Confirm button (check mark).
Replace handset.

Unfortunately I've already tried both of those. But thanks Dave!

press 2-8-9 at the same time, while pressed power/ boot up phone and password is 124816