atcomsystems.ca/forum Forums TDM Business Telephone Systems Inter-Tel Telephones & Systems Block incoming call

I have done the above but when I select "Collected Digits" for the number I want to block I no longer can enter a Ring-In Destination. It rings to the Primary Attendent. My doc says, "If the collected digits plus the base digits do not make up a valid ring-in destination, the call is routed to the primary attendant."

I'm running DB Studio 3.2 with an Inter-tel/Mitel 5200 version 3.2.4.59

Am I missing something?
Thanks in advance.

Nothing new to add to this, just how I listed the steps out for myself:
Make an existing DID ring to a new call routing table.
Set that new call routing tables’ Call Routing Key as Outside-Party Number.
Make its first entry the number you want blocked, and set it's destination as a hangup CRA.
Make 2 new, separate patterns “+” and “E” and set the destination to wherever you want the 'good' calls to go.
The good calls go where you want, the blocked number gets hung up on.

DnR, I do this the opposite way. Whenever I install a system with PRI, the CO trunk group points to a CRT using Caller ID to route, with E and + pointing to a second CRT routing based on DID.

That way I can intercept any calls from the harassing caller and dead-end them regardless of which number they call and after checking my CID list, I then route based on DID normally.

Just a thought.