atcomsystems.ca/forum Forums Other TDM Phone Systems Vertical Telephones & Systems SBX Idea

dtcd21 & Don. I only wish i had a couple of SBX installs a month. As such, I have actually started my own installation programming cheat sheet. Examples of other commonly used settings could be a real aid for many of us. Too often, I seem to be learning the same thing over and over. I seem to forget things all too easily on this system.

For me, having a few procedures written down helps me to avoid forgetting to do them. One such example is PGM 147 to change CID display from number to "name". Yes, I will eventually put this into a generic default uploadable database but I'm not there yet. Using PC admin to regularly enter this general data is helping to raise my comfort level.

It helps if you run one in your shop! Just today I changed the the default IP to end in .200 no problem. Changed it in pcadmin, too but it would not connect! :bang:

Be sure to reset system after changing IP.

I'll throw somethin together with everything and try to give an explanation of why I do it how I do it. Like MNDAVE said that is one of the many things I do for the basic install. I have a 308, 616 base map for each too they get annoying though as things seem to change from sbx to sbx we get sometimes.
Yeah you don't need a hunt group to ring multiple phones you just do it through the co ring assignment and add each station individually. In some situations depending on what the customer wants you may need to pick one or the other to use. For example I used a hunt group on a system where half the phones rang for a call center order taking type outfit. They didn't like it because if they were on the phone and someone else called in there was no indication out of their 9 lines which one was the incoming even if I enabled DID Call Wait. Ended up putting the individual stations in the co ring assign for shits and giggles and low and behold it showed which line was ringing in the screen as opposed to the hunt group pilot and it made an alert sound in their ear. UCD group just marks them as busy and lets them alone if they're on when a call comes in. Some people will want one or the other so.
Once you get a few under your belt you'll get used to them, they are probably one of if not the easiest system to pgm IMO.

Yup!

This was done and could even ping it! Changed it back to default. I'll work on it later!

You've got to give the first credit to jimmy29 though. He beat me to the draw on that answer!

Jim,

Make sure you assign the default gateway as well. Yeah, I know it should work without it, but some times doesn't.

-Larry

I was playing with AA/CCR yesterday and got the system to answer but it wouldn't recognize my dial inputs! So this morning I start back trying to figure this out. You have to set the DISA attribute! Works perfect! Unbelievable :bang:

You must have missed my post about CCRs. You don't set them to ring in Co ring settings, they work only with DID or Disa as you now know!