atcomsystems.ca/forum Forums Other TDM Phone Systems Telrad Telephones & Systems telrad 818 start up problem, HELP !

Look at the Tab of the MPD Card is it Orange?
If so its a 128 (S60 if in a 818 cabinet). If the Tab is Red and has 818 on it its a 818.

Here's what is on the MPD card:

Telrad
Digital Key BX

Memory Cartridge Genric

Release: SBU5.03 (must be the software ver.)
Date: 20.03.97

[barcode]
01224

Cat. # 76110535012 C1

____________________

I'll find out what color the Tab is today.

____________________

By the way, Thanks goes out to everyone for the Help !

fonetec

[This message has been edited by fonetec (edited August 06, 2003).]

[This message has been edited by fonetec (edited August 06, 2003).]

76-110-5350 is a 128

Thank You for IDing the system

Now I have to get it up and running.

DTMF sent me the program SBU5 for the 128 also.

Which file should I use on the floppy's (that are listed above) to re-program the system.

Im going over to the site first thing in morning.

I'll let you know how it goes

fonetec

Don't use any of the above floppy's, they are back-ups, use the 128 programming software, install that on your computer and connect to the MPD card, then when logging in it will ask for the CFG file use medical, it won't find it on your computer but should give you the option to load it from the system. Then go at it. DTMF or SS can help you with anything else, also make sure you have the interface cable that connects to the MPD card or you've wasted a trip.

Good luck and let us know how it goes.

Load the software I sent you then create a new file and then back up the programming to that file then you can see how it's set up and change what you need to. Don't use the floppy's that you found.
Sorry it took me so longbut i was out in the field the last couple of days.

Hey it's ok, I'm just thankful for help and time you guys have given me.

DTMF I will call you in the morning if I need help.

fonetec



[This message has been edited by fonetec (edited August 06, 2003).]

DTMF I took the .exe and .ini file edited the .ini file from SBUM5 to SMU5 and that worked and then it would let me pick com ports and log into system.


I was told by another tech that the ext.s were wired wrong, that the telrad's are wired a standard system, and that's why the phone's where not working.

I'm going to check the connections, but I bet that's the problem.

I did not do the wiring I trusted it to someone else, my mistake if the what it is ?




[This message has been edited by fonetec (edited August 07, 2003).]

[This message has been edited by fonetec (edited August 07, 2003).]

[This message has been edited by fonetec (edited August 07, 2003).]

Just a word of advice. Do a system backup then default the system then do a complete restore from your backup. The way I read your post (I took the .exe and .ini file edited the .ini file from SBUM5 to SMU5) could mean you still have 818 programming in the 128. That will be trouble.

The led on the MPD card has never been on since the first time we powered up the system.

Two leds on OCD card come on for about thirty seconds and then go out.

The led on ELD card stays on.

Does this mean the MPD card is not working ?