atcomsystems.ca/forum Forums TDM Business Telephone Systems Panasonic Telephones & Systems Link Panasonic to Nortel w/ PRI

if you use system>number plan>main> other pbx extensions, set lead number of extensions here. then use private network> tie table, enter lead number i.e 6 remove 0 add 0 trunk group ( ti/pri trunk group)

from the tde if you dial 601 it will pick up the pri and dial 601 to nortel.

you can also point ddi to 601 and it will call 601 on pri/t1 link

I did not realize tde was that flexible thanks obt you know this system as well as tech support!So if you had ext 601 to 661 like he said there are possibly 60 did's on the mics will that entry work for the whole 6xx series like 600 thru 699?

i guess what i am asking is can i make that entry 6**
instead of 601?

yes, it is telling the system that anything starting with 6 will go out on pri/t1 or reading back , you would add 2 and 5 as other system and in tie table tell it what trunk to go out on.

so dialing from tde would be a 3 digit operation

Make sure the trunk group that is linking the system to have cos 1 and co - co duration timer is set to none

I am sorry i was editing while you replied so 6**
is a good entry?

no **, just enter 6, after that it will send 6 and as many numbers as you want after 6,

ok thats how you lost me it says 3 digits instead of up to 3 digits i was thinking of the old days old td days where stars were wild cards !

SUCCESS!

Gentlemen: I'm pleased to report that this setup is working A-OK with the Telco PRI attached to the MICS and the link between the MICS and the TDE200 setup as PRI. Here is the config I used:

TDE200:
PRI setup as QSIG-Master, NI2, all numbering plans = "private", all types of number = "unknown"
System>Numbering Plan>Main>Other PBX Extension contains leading digit of all MICS extensions (2,3,5 in this case)
TRG 7 uses dialing plan table 4
Dialing plan table 4 contains 2XX,3XX,5XX, and inserts 9 for NXXNXXXXXX & 1NXXNXXXXXX
Private Network>TIE Table = left at default
CO Line Settings = all channels of PRI set to TRG 7
DID Table = all TDE extensions as 3 digit DID pointed to extension as destination

MICS:
Hardware>PRI Card settings = NI2, ClockSrc = TimMstr, SendNameDisp = YES
SystemProgramming>BusName = NORTEL
SystemProgramming>Rem Line Access = PRI channels all have access to remote package 2 which allows calls to Telco PRI
Lines = target line programmed with 3 digit DID for each MICS extension


All seems to work great, just not sure (highly doubt) that this setup would allow for centralized voicemail.

I should also mention that both Called ID Name Display and Caller ID Name Display are working.

well done, glad to hear it, did you have to put the pri on to the MICS for routing reasons?

No, that's just how it's currently setup. I'll probably move it over to the TDE after hours. (Not sure if the TDE will allow the MICS to dial through as easily as it works the other way...)