atcomsystems.ca/forum Forums TDM Business Telephone Systems Toshiba Telephones & Systems CTX100 install

Sorry that I misread your post about changing the tone of the intercom, I somehow thought you were talking about the ring tones so two people close together could hear if it was their phone or the other phone that was ringing.

Maybe I am missing something, but if you set doorphone RINGING, how would that come across as a voice annouce to the page group?

If you set the door phone to ring a phantom, you would have a phantom owner and put the phantom button on each phone and set it to ring.

Now if I've screwed up anything this time, let me know and I will start drinking Becks before I read the question.

A Becks sounds good to me.. Is it happy hour yet?

With the pressure on me keeping this place going with every possible crazy thing happening, every hour should be a Becks hour. It is half past midnight, and yes that is a Beck's hour right now.

Thanks for the idea, I'll toast you and the bitter cold weather you must be having right now.

Well you probably live down there, the warmer part of Maine, 15 below in Allagash was a bit much for me.

Hi everyone,

I just inherited a CTX100 w/ IVP8.
I need to find out how to reset the voicemail passwords. There was a suggestion on this forum of taking the ***** and editing a certain line in **** file, however I was not able to find that line.
I am running WinAdmin 1.13 if it makes a difference.
I would appreciate someone PM-ing me on how to accomplish this task.
Thanks for your assistance,
Chris

Welcome to the board BUR01. We can't post instructions on how to reset passwords on this open forum. But I have PM'd you. Thanks.

My CTX100 is working great, but there are a couple of nagging problems.

1. One of my 20 button phones only works partially. The left 10 buttons work, but the right 10 buttons are dead. I tested the phone at another port and it worked fine. Why would that port have this problem?

2. How can I keep the caller id information on the screen when I pick up the phone. It goes away immediately and starts timing the call.

Make sure the phone is programed as a 20btn phone sounds like it is programed for a 10 btn.....try hitting your page soft key on the caller ID??

I program my system using WinAdmin. It looked like the program took the change from a 10 button phone to a 20 button phone. That port did have a 10 button phone at first. The WinAdmin screen shows me the right 10 buttons are programmed.

You mentioned a soft key for caller id. I would prefer not to program a key for this purpose. I would rather the screen be used for caller id than to time my call. Maybe this is not programmable.

if you want to store caller ID you have to program a CLID key.. and enable call history in the station dkt tab.... press the CLID button and use the volume up/down to scroll through

Thanks for telling me how to use the CLID button. It works quite well.

I fixed my other problem, where the right 10 buttons of my 20 button phone did not work. I just deleted that station from the programming and reprogrammed it.

- John