|
|
Joined: Jun 2002
Posts: 33
Member
|
Member
Joined: Jun 2002
Posts: 33 |
I have an 8X24 with a 7324 with (1) KLM and I have the manuals and have installed the entire system with the exception of the KLM. There is no detail on how to connect the power supply. It was stated use a 4 pair wire and wire to the brown pair, however my KLM only has 6 conductors at its connection. Do I wire to the outside pair which would be green? Sorry, I am a neophyte at this, but I have gotten this far. If I do connect to the outside pair, does it matter the pos. or neg. polarity?
Thanks for any help
|
|
|
Nortel Phone System Service in Canada
Do you need a Nortel Phone System technician or specific Nortel parts?
Atcom to the rescue! Our telephone techs have qualified experience servicing and troubleshooting Nortel CICS, MICS, & BCM telephone systems.
Service in Canada from sea to sea.
|
|
|
Joined: Mar 2001
Posts: 577
Member
|
Member
Joined: Mar 2001
Posts: 577 |
power supply wires to the 2nd pair of the station jack. neg - wht/orange pos - orange/white
or
neg - black pos - yellow
|
|
|
|
Joined: Apr 2002
Posts: 305
Member
|
Member
Joined: Apr 2002
Posts: 305 |
like the above but, black is postive ,and yellow is negative.
Good luck.
|
|
|
|
Joined: Apr 2002
Posts: 1,101
Member
|
Member
Joined: Apr 2002
Posts: 1,101 |
3. WHAT IS THE WIRING & PROGRAMMING PROCEDURES FOR A CAP MODULE
WIRING:
The Norstar® CAP module needs an external power source. A way of providing this source is by wiring in the VP324 24-volt DC power supply. In this example a 6 conductor modular jack is being used. The power supply can power two CAP modules. To connect second CAP module you will add another power pair to the 3rd pair on the 6 conductor modular jack. You can have a maximum of 5 CAPs “central answering positions†per system. The CAP can only be a 7324 and you can attach 2 CAP modules to a 7324.
1st KLM Power Pair pin 5 Yellow -24 V pin 2 Black Gnd
2nd KLM Power Pair Pin 6 Blue -24 V Pin 1 White Gnd
PROGRAMMING:
1. Have the CAP modules attached to the telephone with power supplied. 2. Enter SYSTEM PROGRAMMING 3. Select SHOW and then select NEXT to CAP ASSIGNMENT 4. Select SHOW 5. Cap1:none is displayed, select CHANGE 6. Cap1: xxx, enter the extension number of the CAP with one or two KLMs attached. 7. Exit programming
If all else fails, use a BFH.
|
|
|
Forums84
Topics94,398
Posts639,335
Members49,806
|
Most Online5,661 May 23rd, 2018
|
|
1 members (justbill),
191
guests, and
27
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|