atcomsystems.ca/forum Forums TDM Business Telephone Systems Mitel Telephones & Systems SX200 Analog no ring generator?

LH yes we are!

Sharu,

Start another thread for your issue so more people see it. You don't want to add a comment/question on a completely unrelated thread. On this thread we are talking about equipment that is 20+ years older than the 3300.

Thanks everyone,

I replaced the R/G and the fuse it blew when it went and all is well in Whoville! The old R/G smelled and when I turned it over, 2/3 of the back of the circuit board was scorched (Ouch!). Word to the wise, if you have to replace this thing, make sure you have a long slotted screwdriver otherwise getting the cage off of the R/G can be problematic. :bang:

Jon, are you kidding! Why didn't you just replace the whole back door?! You'll probably be back out there in 6 months or less to replace the whole door!

LH,

Wanted to but the customer didn't want to spend the money. This was the only other option I could give them.

Supposedly want to upgrade to an ICP in 4- 6 months going on close to 48 months now.

Customer had lines disconnected (had a T1 w/channel bank and now down to 8 lines) without calling me and now every time the system is rebooted 4 trunk cards send alarms and the just sit there and flash. Customer didn't even want me to go through the programming to fix the line issue because the owner didn't want to spend the money.

One of these days the unit is going to fail and then it will be an emergency, especially if the Dean card goes bad.

Sounds like they deserve whatever grief they get. But then they expect you to jump through a hoop while bending over backwards to get them running again.

Amen, Steve!

The sad part is the owner just changed flags and spent 800+k on required renovations and didn't think to include an phone system upgrade in it. :bang:

Hey, everybody knows 'Mitels never die'.