atcomsystems.ca/forum Forums Active Threads Since Yesterday

I believe I did look at 20-09 it didn’t seem to make a difference. Basically it works on incoming calls only
This problem is not the reason for my post, but I just thought if I could get rid of the fact that these people are getting call waiting tones, which may alleviate some other issues that they’re having

Basically, this is a nursing home with a lot of different people coming in at different times in their complaining about calls getting disconnected

The system has been in there for years very few complaints. I know they use cheap analog phones.


Some people use the phone some people don’t some people have more people calling them. It’s always different

It’s two separate aspire M‘s tied together through voiceover IP card
Each system has their own PRI
However, the incoming calls always come into the first PRI in system a and then travels to system B

I’ll go there and replace the Jack maybe swap a pair out but nobody really knows if the problem gets resolved or the people just give up. It’s very confusing hard to troubleshoot like I said nobody else seems to be having problems just these analog extensions.


🤔

On my Verizon FIOS phone line, the system works perfectly. Tried adjusting db settings in 1001, no change. Also inline resistor 200ohm on th trunk. no change. 50% of calls fail. Weird.

We do a lot of school paging, for in ceiling speakers we were using TOA F-12CU2, (on the expensive side)
Now we are starting to use Lowell ES-52T ceiling speakers.

Just other options you may want to consider.

Dan S