|
|
|
|
Joined: May 2003
Posts: 50
Member
|
|
Member
Joined: May 2003
Posts: 50 |
I'm having trouble with a Magix rls 1.5 ver 6 using analog lines. Incoming calls are not disconnecting. Even after removing the line cord from the line ports the call stays active on the switch. I am hoping this has been clearly documented and addressed by Avaya, but I am not seeing it. Thanks for your help.
|
|
|
|
|
Joined: Apr 2002
Posts: 646
Member
|
|
Member
Joined: Apr 2002
Posts: 646 |
With loop-start lines you need to set the LS-Disconnect to YES. Default is NO.
|
|
|
|
|
Joined: May 2003
Posts: 50
Member
|
|
Member
Joined: May 2003
Posts: 50 |
That was the 1st thing I checked.
|
|
|
|
|
Joined: Apr 2002
Posts: 646
Member
|
|
Member
Joined: Apr 2002
Posts: 646 |
Are you getting a disconnect signal from the CO? Put a meter on the line and see if the polarity reverses or the current goes to zero when the far end hangs up.
|
|
|
|
|
Joined: May 2003
Posts: 50
Member
|
|
Member
Joined: May 2003
Posts: 50 |
I did not check that. I removed the line from the switch on an active call and the switch did not disconnect. That leads me to believe that the switch is not working right.
|
|
|
|
|
sts pft
by davetel - 01/14/25 01:31 PM
|
sts pft
by davetel - 01/11/25 06:42 PM
|
|
|
|
|
Forums84
Topics94,461
Posts639,657
Members49,825
| |
Most Online5,661
May 23rd, 2018
|
|
|
0 members (),
28
guests, and
28
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|
|
