Creating a phantom loop on an Option 11

Products from our Sponsors

Print Thread

Rate Thread

Creating a phantom loop on an Option 11 #143786 06/28/09 10:34 PM
Joined: Jun 2009 Posts: 3 Currently in Okinawa redramjim Member
redramjim Member Joined: Jun 2009 Posts: 3 Currently in Okinawa	I've attempted to change an existing analog loop into a phantom loop in LD 17. I am not receiving the prompts that are laid out in the documentation. REQ: CHG TYPE CEQU DDCS TDS CONF DTDT DLOP PRI2 APVL DTI2 SYNM Any suggestions on how to fill in the other prompts after "TYPE"?

Nortel Phone System Service

Nortel Phone System Service in Canada

Do you need a Nortel Phone System technician or specific Nortel parts?
Atcom to the rescue! Our telephone techs have qualified experience servicing and troubleshooting Nortel CICS, MICS, & BCM telephone systems.
Service in Canada from sea to sea.

Re: Creating a phantom loop on an Option 11 #143787 06/30/09 01:16 AM
Joined: Jun 2007 Posts: 627 Janesville Wisconsin mj_wald Member
mj_wald Member Joined: Jun 2007 Posts: 627 Janesville Wisconsin	I "think" a phantom loop needs to be loop 159

Re: Creating a phantom loop on an Option 11 #143788 06/30/09 03:05 AM
Joined: Aug 2004 Posts: 1,712 Likes: 39 Calgary, AB, Canada Toner Admin
Toner Admin Joined: Aug 2004 Posts: 1,712 Likes: 39 Calgary, AB, Canada	I doubt it has to be 159 on an Option 11, but I do think there's a specific range it needs to fall into. I also highly doubt it can be "changed" from a 500 type to a phantom... I work with a phantom loop on an 81C that's # 156. Looking for a VoIP Phone Canada provider? Put Atcom's valuable VoIP expertise to work for your business today!

Re: Creating a phantom loop on an Option 11 #143789 06/30/09 07:41 AM
Joined: Jun 2007 Posts: 627 Janesville Wisconsin mj_wald Member
mj_wald Member Joined: Jun 2007 Posts: 627 Janesville Wisconsin	I was able to move a 500 from 159.X.X.X to 36.X.X.X So it should be able to be moved regardless of the TN.

Re: Creating a phantom loop on an Option 11 #143790 07/08/09 12:11 PM
Joined: Jan 2004 Posts: 82 Oklahoma, USA Baron-B Member
Baron-B Member Joined: Jan 2004 Posts: 82 Oklahoma, USA	The phantom loops are set up in LD 97. You'll have to check the NTP, but I believe the valid loop numbers are 96, 100, 104,... Then the phantom / virtual sets are on "cards" in the 60s and 80s. Make sure you have the NTP books to refer to, or you'll have problems!