I'm trying to mirror the port on our 3300 MXe III so I can run a Wireshark capture. I've done this before, but it is not working now. I connected via a raw session to port 2002 and entered xmirror "2 1" command. The interface says the mirroring is in place, however, I seem to recall the lines on the second port were lit, even without a PC connected to it. Now they are all dark. I run the icpL2StatShow 2 command and the port status says "Down". How do I change it to "Up"? Is there another port I could use? Any help or suggestions would be appreciated. Thanks.