|
|
|
|
Joined: May 2001
Posts: 175
Member
|
OP
Member
Joined: May 2001
Posts: 175 |
Ok Ive been battling this PROTEGEVoice SVP-4 system and I think I know where the problem is. I am trying to add a mailbox and am connected to the  mail using Procomm as the Protege manual recommends however when I attempt to define the mailbox type by depressing the "ALT" key and the letter "Y" the "SD" light on Procomms RS232 indicator the "SD" (send data) light never blinks, therefore I am unable to assign the mailbox type. Has anyone seen this issue and or does anyone know the fix to my problem? I really appreciate any and all input if anyone has any ideas or suggestions. Thanks fellas FLdiver
|
|
|
|
|
Joined: Dec 2007
Posts: 6,785 Likes: 14
Retired Admin
|
Retired Admin
Joined: Dec 2007
Posts: 6,785 Likes: 14 |
You're making it too hard. (or the manual is  ) Here is the easiest way: - In Mailbox Administration press [F3] Clear Screen.
- When the options Clear Screen.......? (y/n) enter Y
- Now you will have blank form.
- Enter the number of the mailbox you wish to create and press ENTER.
- The screen will stste Information Not Found..[F1] For Closest. _____| To Continue
- Press the Enter key and you will now have created the new mail box.
Remember to press [F5]Save when you are done. You can write down all the settings from an existing mailbox of the same type for ease of data entry.
|
|
|
|
|
Joined: May 2001
Posts: 175
Member
|
|
OP
Member
Joined: May 2001
Posts: 175 |
that does not work if you do not put in a mailbox type when you hit F5 to save you get an error mailbox type. I have found that to choose a type you have to hit "ALT"Y but procomm never sends that data Im stuck
|
|
|
|
Forums84
Topics94,111
Posts637,978
Members49,726
| |
Most Online5,661
May 23rd, 2018
|
|
|
|
|
|
