Business Phone Systems

Previous Thread
Next Thread
Print Thread
Rate Thread
#482644 11/07/11 07:33 AM
Joined: Nov 2011
Posts: 3
OP Offline
Joined: Nov 2011
Posts: 3
Hello, new to the forum. We currently have a Valcom V-2006A paging system hooked up to Cisco Unity/Subscriber/Publisher going through a Cisco 2811. We are moving over to a VOIP phone system by CudaTel. We have purchased a Cisco SPA-3102 to connect from the CudaTel to the Valcom using the FXS port.

I'm not sure if anyone on the board has worked with the CudaTel system before and tried interfacing with a similar paging system. The CudaTel sees the FXS port as a provider port and requires a line number. As far as I can tell the RJ11 goes directly from the patch panel to the Valcom and would not have a phone number associated to it.

I am not versed in the warranty Valcom provides for their products so along with posting here I have also sent Valcom support an email describing the situation. I am also actively working with CudaTel support to figure this out.

Any help or suggestions provided would be greatly appreciated.

Thank you.

Atcom VoIP Phones
VoIP Demo

Best VoIP Phones Canada

Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.

#482645 11/10/11 01:46 AM
Joined: Oct 2010
Posts: 40
Joined: Oct 2010
Posts: 40
Although your question has been answered by our support team, I wanted to post the reply on this board.....

There are a couple of possible scenarios:

If an FXO port is available on the SPA-3102, the V-2006A will connect directly to this port. Ensure the battery feed switch (SW6) is in the ON position.

If an FXO port is not available and an FXS or ATA port is utilized, a V-9970 (Station Level Page Adapter) would would be required between the FXS or ATA port and the V-2006A. The V-9970 will answer the incoming call between the first and second ring, then provide a line level output and close an associated relay that will trigger the V-2006A. In this scenario, the battery feed switch (SW6) would need to be in the OFF position.

To test the V-2006A, plug an analog phone into J4 or connect a buttset to the w/bl pair on the block. When off-hook, an intercom dial tone should be heard. From there, enter a desired zone (1-6) or All Call code (0) and page.


Valcom Tech Support

Moderated by  metelcom 

Link Copied to Clipboard
Forum Statistics
Most Online5,661
May 23rd, 2018
Popular Topics(Views)
205,811 Shoretel
183,681 CTX100 install
183,232 1a2 system
Newest Members
Jackie22, Griffin, Paso Telecom, goalieonyxvs, kb8doa
49,726 Registered Users
Top Posters(30 Days)
Toner 11
Yoda 6
Lacota 3
Who's Online Now
0 members (), 31 guests, and 28 robots.
Key: Admin, Global Mod, Mod
Contact Us | Sponsored by Atcom: One of the best VoIP Phone Canada Suppliers for your business telephone system!| Terms of Service

Sundance Communications is not affiliated with any of the above manufacturers.
©Copyright Sundance Communications 1998-2023
Powered by UBB.threads™ PHP Forum Software 7.7.5